Page archived courtesy of the Geocities Archive Project https://www.geocitiesarchive.org
Please help us spread the word by liking or sharing the Facebook link below :-)


geocities mirror geocities mirror geocities mirror geocities mirror geocities mirror geocities archive geocities archive geocities mirror geocities mirror geocities archive geocities mirror geocities archive geocities mirror geocities mirror geocities mirror geocities mirror geocities archive geocities mirror geocities archive geocities archive geocities mirror geocities mirror geocities archive
geocities mirror
Walnut Wine Cabinet
geocities archive
My Design, 2002. Here's another piece from Lancaster County walnut supplied by the ever-generous Basil Bailey.  This time, however, he gave me a few pieces of crotch grained wood and I used them to full effect on my most ambitious project yet.  This is a frame and panel cabinet tbat I designed, featuring bookmatched crotch veneered panels on both sides and the doors.  I resawed the veneers myself at Paul Lloret's (he has a larger bandsaw than I do).
geocities archive
Of course, these photos don't begin to do justice to the spectacular grain, but they give an idea.  The finish I used was a homemade mix of poly, linseed oil, and solvent, which gives it a very nice depth.  The hardware is from Horton Brasses.  Great products and spectacular service.
geocities archive
geocities mirror
This shot shows some of the more spectacular grain on the side panels.  I pretty much designed this piece around the striking figure I got out of those pieces of crotch wood.  It looks pretty drab here, but close inspection reveals amazing chatoyance and changing patterns, especially if you move the light source!  Not many folks would think of getting down on their knees and waving a lamp around to enjoy a piece of furniture, but it's worth it on this one!  The side panels are, if anything, prettier than the doors.  I managed to get four veneers out of this piece, so the panels on both sides are essentially identical.  I put beads into both the top rails to carry the lines from the upper and lower drawer supports around to the sides.
geocities mirror
...and here are the guts.  The 'shelves' are dowels that run between front and back lap-joint frames that I inset into the inside corner of each leg.  That, plus the mortise-and-tenon joinery in the rails make it extremely sturdy.  And, by the way, it made for a very challenging final glue-up, but that's another story.  As is usual with my pieces, there is no metal used for any joinery save attaching the top.
geocities archive
geocities mirror
This shot, showing the drawer joinery, was made with artificial light, thus the different color. 


I used just about every tool in my shop on this piece.  Hand tools, power tools, borrowed tools.  The wood Basil gave me was straight from the sawmill, so there was plenty to do.  For a change, though, I had some extra time to work on it so while it is the most complex piece I've made, it was one of the quicker ones, in elapsed time.  Lots of hand toolery here, as usual... I won't bore you with the details.  The drawer and back (and rear shelf support frame, if you care) are from pine that I reclaimed out of our house during our various remodelings.  I admit I'm pretty proud of this one.

geocities archive
1